Televes PicoKom 560522 Indoor Antenna Amplifier DVB-T2 with automatic gain VHF / UHF LTE700 / 5G with 2 outputs

Televes DVB-T2 indoor antenna amplifier PicoKom 560522 2 outputs: VHF / UHF - LTE700 Ready

• Plug & Play, without adjustments: incorporates automatic gain adjustment, without compromising the signal quality
• Aesthetic design and small size: Can be installed in 100x100mm connection boxes
• EasyF connection system
• Integrated high performance power supply: low consumption (40% less than a standard amplifier)
• Fully automated production and subject to rigorous quality controls

Main features

• DC switching ON / OFF switch, for powering preamplifiers or BOSS systems
• Easy assembly, maintaining the minimum bending radius of the coaxial cables
• Wall screwable

Application Examples

EasyF connection system: simplicity and savings

EasyF is an innovative concept of connecting the internal conductor of the coaxial cable (core), which is inserted directly into the device increasing the reliability of the connection. Furthermore, thanks to the absence of "F" connectors, it is possible to reduce the frame and ensure the connection of two cables with a single screw.

• Real time saving: it is possible to speed up the installation, since it is not necessary to carry out the connectorization of the coaxial cables. In addition, the process of screwing the connectors into the device is avoided, which is sometimes complicated when there is not enough space
• Reliable connection: the door that holds the cables prevents the coaxial cable from loosening
• Cost savings: no additional connector (either "F" or "IEC") is required
• Space optimization: the inputs and outputs are always located on the same side of the device, avoiding bending coaxial cables and facilitating work inside cabinets and distribution boxes.
• Easy assembly in three steps: just connect and unscrew the covers to connect two cables:
  1. Unscrew the divider cover to access the connection
  2.Insert the pre-stripped coaxial cables
  3. Close the cover and screw to secure the connection

Find out more about the reliability of the EasyF system

With EasyF, the connection of the coaxial cable in the device is made through an automatic system for inserting the cable (internal conductor) by contact, without the need for welding.

• Same as day one: device life time increases when possible deterioration of welds is eliminated over time
• Reduction of failure rate: generally produced by cold welding
• Optimization of electromagnetic behavior: at high frequencies
• Strengthening our commitment to the environment: contamination caused by the welding process is eliminated and electricity consumption in production is reduced